Can an Airsoft Lower Receiver Work in a Rifle

Airsoft guns differ from existent guns, so following that logic, the airsoft accessories should not fit on the existent guns and vice versa. Nonetheless, this is not exactly true, at to the lowest degree non for all accessories.

I take compared the "real" gear and the ane that can be plant in airsoft stores and shops and I take plant what parts tin can exist used on both, the real guns and replicas just as which accessories are but non fitting well at all.

And so, what would the short answer look like, can the airsoft accessories be used on real guns and vice versa?

Inner parts simply exercise not role, but some airsoft accessories like Flashlights, red dots, barrel clamps and holsters tin be used on existent guns too, however this depends on the quality of the manufacturer. Many parts and accessories are also poorly designed and will be hardly usable on anything with real recoil.

Nosotros are all aware that you lot tin find airsoft accessories such as optics at very low prices such as $thirty, the real counterpart would certainly cost at to the lowest degree $300 and this is a good introduction to let yous know that at that place might be major differences that may not be seen at showtime sight.

We volition become through all available accessories and parts and say a few words about them, but let's beginning mention that no airsoft inner parts volition ever piece of work on real guns and vice versa.

Therefore, nosotros will just mention the outer parts and surprisingly some piece of work quite well in both cases.

It is as well a rule of thumb that real gun accessories perform improve and are more than probable to detect the purpose in airsoft world, while the airsoft accessories frequently lack the quality that would exist required to sustain the purpose on existent guns, especially if the existent guns are used for existent life applicable scenarios.

Can yous convert airsoft gun into a real gun?

At that place are some parts similar the lower gun receiver that forms the body of a gun and in some cases the airsoft gun receivers can seem every bit a great pick.

At the outset look it has everything and it seems that everything will fit in information technology, notwithstanding as well the possible quality metal build, it can hardly fit the real gun inner parts.

The most common problem is to fit existent gun parts inside the frame because well-nigh parts of the airsoft gun are designed to fit smaller parts and machinery, later on all a BB differs from a bullet by far.

Technically speaking, it is possible to adjust the sizes and fit those real gun parts in, but it would require tremendous amount of work with diverse tools and peachy understanding of the affair.

You would also demand to accept an admission to all those real gun parts and it is easier to purchase a gun illegally if someone desires to break the law anyways.

In any case, it simply is not worth it and nosotros would end up with a conclusion that information technology is easier to create an improvised gun from basic metal tubes and other affordable parts that with proper technology tin get an constructive weapon.

This is besides a reason why there is no need to worry that airsoft guns can be hands transformed into existent guns and be used for illegal activities.

However, some states have constructed the law against airsoft guns exactly because of this irrational fearfulness.

Flashlights and red dots are e'er useful

There is not much to say regarding flashlights and red dots considering they do not differ in any way other than the quality.

There are many flashlights and crimson dots on the market and some are better and some are worse, quite elementary.

No matter which 1 we take as an example, every unmarried ane will exist usable on both real guns and airsoft guns and the quality of performance is the only real factor.

However, flashlights and cherry-red dots need something to be attached to and it leads united states of america to the next parts we are going to discuss.

Gun Rails and Butt clamps

Without these parts you can not adhere annihilation onto your gun, whether it is the airsoft or a existent one.

Airsoft rails and butt clamps differ in quality from their real counterparts and therefore it is not suggested to use such airsoft parts on real guns, just the existent rails and clamps can be used on airsoft replicas.

The reason backside this is that such airsoft parts often lack the stiffness that is required for the optimal precision when exposed to the real recoil.

But, the low quality and cheaper airsoft parts can not sustain the gun recoil and will simply give upwards at a certain time. The aforementioned can be said about the estrus, the airsoft track are more likely to cook.

The existent gun rails and barrel clamps are manner more expensive and are treated as important gun parts, therefore it would brand more logic to put them on airsoft guns if you accept the access to them and if they fit the model, but what is the purpose of that? It won't requite you an edge.

Manus guards, Runway covers and protectors

We must mention manus guards, rail covers and protectors because they are very common parts on guns, particularly on real guns.

The thing with these is that the airsoft replicas have a trouble with sustaining the heat and are very likely to interruption nether the recoil.

Using such existent parts on airsoft guns are once more, adequate, merely in that location is no point in doing that.

Scopes

Having a real, loftier-end scope on the airsoft gun is a wonderful thing, in other mode around, non so much.

Scopes are extremely dependent on the tier and probably any airsoft scope won't exist able to sustain the heavy recoil on the guns. The other problem is accuracy on long distances, airsoft replicas only are not built for this.

In other manus, at that place are players who attach the real high-tier on their snipers and written report that they piece of work swell. I hateful, information technology probably might give you lot an edge because the quality departure is unquestionable, but the price difference in unquestionable too.

Grips and stocks

Grips and stocks profoundly depend on a model of a gun, just ofttimes can exist used vice versa.

I don't know much about grips and how often would they fit in majority of guns, but I do know that there are some realistic i:one airsoft replicas that are identical to their counterparts and certainly grips fit them.

This is a wide question because again, the exact model is required, but some models definitely fit grips, and then if you take a gun, miss a grip and want to find a cheap option, you lot can look for airsoft grips and try them out if they fit.

We may assume that the quality is worse on replicated grips, but I exercise not think that it is the case. Colt 1991 is known for having a polymer grip and the airsoft replicas often utilise the similar high-quality polymer in manufacturing too.

The same goes for stocks, if they fit, they can be used. All the same, even though I have heard that people employ replica stocks on their rifles, I wonder how long they last.

I mean, I am kind of skeptical that the recoil won't destroy them after some time because I doubt that the manufacturers thought about real recoil when they designed these.

Holsters and Slings

There are many different models of magazine and gun holsters and some will fit both real magazines and guns merely as they will fit the replicated ones.

For instance, in that location is an airsoft gun holster for Glock licensed replica G19 that will also fit the G17.

Not all gun replicas are exactly the same in dimensions, just some clearly are.

Slings can also fit both guns and are pretty much universal, withal there is a general idea that the airsoft slings often lack quality, but it does not have to be true.

Rifle remainder

At that place is no discussion hither, I have not seen a unmarried airsoft rifle rest that I would comfortably use with a real rifle still.

These polymer, non-loyal replicated rifle rests would probably break at very first occasion, especially if we talk most some powerful rifles such as AR-50.

Just avoid them.

A good style to get around legal problems

I have heard stories where people with real rifles missed a stock and decided to go the high-quality airsoft replicated 1 instead of a real i in order to avert the legalities.

Very often when buying the real gun parts, you as well need to become through a legal process before you tin can get the desired parts.

This can be skipped if you make up one's mind to use the airsoft replicated parts instead, however merely a few parts are worth getting this fashion, perhaps the stocks are 1 of them.

Decision

Well, we have constitute out that in that location is not much of a practical utilise of these parts between real guns and their replicas at all.

In some cases you may save some budget or skip the legal norms, but at the cease, in almost cases it does non really thing.

This is also a good way to empathize that airsoft replicas are not really dangerous and are almost impossible to be converted into existent guns.

Some aesthetic and functional parts are available, but none will e'er increment the lethality of a gun in whatever case.

Recommended books to skyrocket your airsoft experience and skills

The commencement volume of the airsoft bible teaches y'all adapted tactics that work inside the field which are based on real war machine tactics.

The second book will teach you and your team well-nigh the essential skill of communication (necessary for squad synergy and this is exactly what separates swell teams from average).